|
What we do: concrete accessories
Tilt Up Systems:
Slab Saver for tilt panel forming to reduce labour, eliminate holes and patching of floor slabs.
Brackets for tilt up panels which are reusable such as the EZ-nail bracket.
CANZAC Slab Saver:
The Revolutionary new Tilt panel Forming System that reduces installation time by 60% and eliminates holes and patching of your floor slabs.
ELIMINATE HOLES BEING DRILLED IN YOUR FLOORS
Saves your Slabs
Revolutionary New Tilt-Panel Forming System
REDUCES INSTALLATION TIME UP TO 60%
- Superquick
- No Drill Bits
- No Patching Required
- Lightweight
- Re-Usable Brackets
- Recycled Composite
COST SAVINGS FOR CONTRACTORS!
BETTER FINISHED FLOORS!
INSTALLATION SHEET
Prior to installation - Concrete contact surfaces must be cleaned of all oil, dust and grease(call for recommended cleaner).
Remove paper backing from adhesive and carefully stick to Slab Saver Shoe in desired location (Max. 800mm OC) and apply Min. 50kgs downward pressure and rotate on Shoe.
Important note: If the Shoe de-bonds with the concrete surface, DO NOT REUSE.
1: Insert "Tail" of Bracket into Slab Saver Shoe.
2: Snap Bracket down in place.
3: Finally, place 3 Wood Screws into the Form.
1: Remove Screws from Bracket/Form Board.
2: Then pull Bracket upward to Reuse.
3: Shoe can remain in place until Form Board is stripped.
Place small pry bar under tail of Slab Saver Shoe and leverage upward. Tape will de-bond with concrete surface.
|
